BlueTree 5000 Uživatelský manuál stáhnout pdf (Strana 91)

12.5 +BPTOIP: Pass-Through Over IP

Description

This command set the modem in a pass-through mode to directly connect the RF module over IP.

Availability

Since FW version 3.3

Command Syntax

AT+BPTOIP=<Dst>,<Action>,<TCP Port Number >,<Server Inactivity Timer>,<Connection

Inactivity Timer>

Response Syntax

+ BPTOIP: <Dst>,<Action>,<TCP Port Number >,<Server Inactivity Timer>,<Connection

Inactivity Timer>

Defined Values

<Dst>

1 RF main port

2 RF secondary port (Not Used)

<Action> Set Command:

0 Stop the pass-through over IP server for the specified RF port.

1 Start the pass-through over IP server for the specified RF port.

2 Restart (Stop and then Start) the pass-through over IP server for the

specified RF port.

<Action> Query Command:

0 Stopped (Pass-through over IP server for the specified port is

stopped).

1 Listening (Pass-through over IP server for the specified port has

been started and is awaiting an incoming connection).

2 Connected (Pass-through over IP server for the specified port has

been started and a connection has been established).

1501-65535 TCP port number (must not be currently in-use by the modem)

1-3600 Server inactivity timer in seconds. The server will be stopped after

the specified delay without an established connection. This timer

cannot be disabled.

0 Disable connection inactivity timer (connection is maintained even if

no data exchange occurs).

1-3600 Connection inactivity timer in seconds. The connection will be

terminated when no exchange of data takes place on the established

connection after the timer expires.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 129 130

Žádné komentáře

BlueTree 5000 Uživatelský manuál Strana 91